English
Chinese (Simplified)
French
Portuguese
Spanish
German
need help on GE HDE coil id problem error 2258107
Access and use of this site is subject to the terms and conditions of our LEGAL NOTICE & PRIVACY NOTICE
Property of and Proprietary to DOTmed.com, Inc. Copyright ©2001-2013 DOTmed.com, Inc.
ALL RIGHTS RESERVED
Property of and Proprietary to DOTmed.com, Inc. Copyright ©2001-2013 DOTmed.com, Inc.
ALL RIGHTS RESERVED
Ernesto Guerra
need help on GE HDE coil id problem error 2258107
March 28, 2012 11:29
Hi, I have a peculiar problem. The unit is not letting me scan on some coils; the only coils that I can scan are the regular Head coil, the knee coil and the body coil. Every other coil I can’t scan; it gives me an error that says “invalid coil connected” and on the error log the error is 2258107. I have try the SRI-3 and reloaded software and still same problem. Can anyone decode this error 2258107? I have also tail the “coilid.log” file and there I can see that whatever coil is connected is been recognized. Thank you for your input
to rate and post a comment
LeRoy Blawat
Re: need help on GE HDE coil id problem error 2258107
March 29, 2012 07:15
Try scanning those other coils in GE Service mode.This won't solve the ID problem, but at least you should be able to find out if those coils are working properly. The coils you are describing are Transmit/receive coils and plug into the Head T/R port, that is if you are using the legacy style green colored connector. If you indeed have this green style connector on the system, then you may have a bent coil ID pin on your integrated pre-amp assembly, which is where you plug receive only coils into. If your coils are using the newer hypertronics style connector (A and B), then you should make sure that you run all diagnostics that you can to rule out the cross point switch.
to rate and post a comment
Bruce Smith
Re: need help on GE HDE coil id problem error 2258107
March 30, 2012 12:04
Ernesto, Leroy gave you a very good run down of where to look. Since the ID log shows the correct coil do not overlook the Crosspoint switch testing.
to rate and post a comment
Marco Flores
Re: need help on GE HDE coil id problem error 2258107
April 02, 2012 04:38
2258107: Coil Check Host coil validation error Body Transmit Enable mismatch detected Due to large cable track and harness
to rate and post a comment
Ernesto Guerra
Re: need help on GE HDE coil id problem error 2258107
April 03, 2012 04:56
Marco, Bruce and Leroy, I really appreciate your comments and help in this matter. This unit is an HDe using the new style LPCA with only port A connector, I have tested and checked the multicoil interface assembly and I have all the voltages and the preamps are also working, I swap the once use on head mode and tested the other preamps this way. I have run diagnostics on the Driver module and check to see if the unit is switching from head to body mode and it is. So the only thing left to try out is the 8 channel switch. The only way for me to test is by getting another one since I don't have the MCR III tool to test it. The only problem is that no vendor has this part at this time, only GE. Once again thank you for your help, any input is appreciated.
to rate and post a comment