Jesus E Mendez
GE Vivid i Freezing Issues
January 23, 2020 11:01
Im working on a Vivid i with freezing issues. I think that the problem is caused by the BEP assy. I tried to perform a software reload and the system still with the same problem in intermittent times. I swap the HDD to try again the software reload and the system was freezes in the middle of the base installation, as the original HDD. Then, I remove the ribbon cable between the BEP and RFI and tried the software reload. Nothing change. If I replace the BEP, the original system option key could be change or the original serial key should be works fine with the new BEP assy?
Thanks in advance for your help
Have a nice day
to rate and post a comment
re: GE Vivid i Freezing Issues
January 31, 2020 10:20
Option key saved in software.
My advice - open machine, remove etx/xtx module and clean, maybe need replace thermal interface (like rubber) prepare new hdd, upgrade BIOS and install new software.
Maximum software - BT12
re: re: GE Vivid i Freezing Issues
February 03, 2020 09:43
Ok, Thanks for answer my post. I will try this step. Have a nice day and thank you very much for your help
January 31, 2020 10:22
Hello, befor changing the bep, reload the software in a new HDD, sometimes the HDD makes that kind of problem ALSO. CHANGE THE MEMORY
February 19, 2020 10:29
If you change the BEP, you will have to reprogram your system ID from the menu on your software installation media.
Primis Medical closeout auctions take place on DOTmed.com. Bid today on 117 lots of medical equipment. Onsite or virtual inspection available.