Konica Minolta Regius 190 Belt Slipping - Service Technicians Forum

Bidding open for ZRG Medical Auctions - Bid Now - Closes Dec 11th

Konica Minolta Regius 190 belt slipping

Tags: PACS / DR / CR / Digital, KONICA MINOLTA


Pete Schliebner

Konica Minolta Regius 190 belt slipping

November 19, 2020 04:37

I had to replace the steel belt between the Subscan assembly and the counter balance weight. The new belt is slipping and it cannot complete the initialization routine, therefore I get error 04061.
I have greased the bearings on the Subscan unit and verified that it moves smoothly on the rails by hand. I have cleaned the belt with alcohol to remove any dirt, oil, or grease and it helped but the belt still slips sometimes, especially after the unit is first turned on. I cannot find any way to increase tension on the belt, but it does not seem loose. What could be causing the slipping?

Log inor Register

to rate and post a comment

Are you overpaying on your surgical monitor display repairs?

At Atlas Electronics we don’t sell new monitors so we are highly motivated to repair your existing equipment. We repair all makes and models of Surgical Monitor Displays since 1981! Call Nick at 214-923-4229 or email direct nick@ehotelrepair.com



one source


RSTI Newsletter



Upcoming Auction Events

Dec 11, 2020 (45 lots)