Mammo Lorad Iii Error - Service Technicians Forum

MAMMO LORAD III ERROR

Tags: Mammo, LORAD

(1)

willmary colina

MAMMO LORAD III ERROR

September 10, 2019 11:56

Hello dears. I have a flaw in a Lorad III who could help me. The device presents a constant alarm at the initialization start that indicates high voltage on the panel. And verify the operation of the isolation transformer and I have voltages in the microprocessor and memory control cards (control). However, there is a short in a fuse called F2 of 5 Amp. Someone could help me in this fault please.

Log inor Register

to rate and post a comment

(10)
(2)

JORGE NAVARRO

re: MAMMO LORAD III ERROR

September 12, 2019 09:00

Hello, if you need copies of the service manual I m able to send you.

Log inor Register

to rate and post a comment

(93)
(16)

Juancho

re: MAMMO LORAD III ERROR

September 12, 2019 09:01

Can you explain in more detail the failure of the MIII?
Regards

Log inor Register

to rate and post a comment

Diagnostic Imaging Training: RSTI (Radiological Service Training Institute)

15,000 service professionals from over 50 different countries have trained in over 35 courses in radiology, mammography, CT, ultrasound, networking, PACS, & DICOM. Classroom & lab facilities to accommodate up to 60 students.

DOTmed Certified
advertisement

 

one source

 

RSTI Newsletter

 

Hitachi