Proper way to repair Olympus light guide tube cover
May 22, 2013 11:32
Fault: Outer sheath broken or Outer sheath & inner fiber both broken
Solution:1.Clean up the fiber inside the connector,remove glue, dirties and all blots,then clean with alcohol.2.Cut the end of fiber and out sheath evenly.3.Wet the fiber with alcohol, apply some special glue.4.Put then back to the right position.5.After dry it by oven, do polishing from rough grind to fine grind.6.Adapt it into light source ,check the light.
Anyone else has more better ways to deal with it, welcome to reply!
re: Proper way to repair Olympus light guide tube cover
May 24, 2013 10:10
If the outer sheath is torn, we replace it. If both the sheath and fibers are no good then we replace both components. This is really the only to perform a proper repair and keep to OEM standards.
re: re: Proper way to repair Olympus light guide tube cover
May 27, 2013 08:45
Yes, if the crack is in the center, we'd better replace a new one, but if it's near the connector,here what we do is to do a small cut ,then reconnect the rest cable.
GBS offers service, repair, rentals & spare parts for your ventilators. With over 40 years of experience our certified & factory-trained biomedical technicians refurbish all our used ventilators. Call today 800.558.9449
dododo
Proper way to repair Olympus light guide tube cover
May 22, 2013 11:32
Fault: Outer sheath broken or Outer sheath & inner fiber both broken
Solution:1.Clean up the fiber inside the connector,remove glue, dirties and all blots,then clean with alcohol.2.Cut the end of fiber and out sheath evenly.3.Wet the fiber with alcohol, apply some special glue.4.Put then back to the right position.5.After dry it by oven, do polishing from rough grind to fine grind.6.Adapt it into light source ,check the light.
Anyone else has more better ways to deal with it, welcome to reply!
to rate and post a comment
Adam Rudinger
re: Proper way to repair Olympus light guide tube cover
May 24, 2013 10:10
If the outer sheath is torn, we replace it. If both the sheath and fibers are no good then we replace both components. This is really the only to perform a proper repair and keep to OEM standards.
to rate and post a comment
dododo
re: re: Proper way to repair Olympus light guide tube cover
May 27, 2013 08:45
Yes, if the crack is in the center, we'd better replace a new one, but if it's near the connector,here what we do is to do a small cut ,then reconnect the rest cable.
to rate and post a comment