Please I need of help.
The machine was working good...I move it from the one place for other the machine is bad.
I dont have the service manual of it.
I holp that anybody can help me.
Dear Mr Raphael Cortez, I'm in a hurry with an ACUSON ASPEN ADVANCED, there was a short circuit in the connector of soft keys located on the back side of the monitor, after that the system doesn't boot and shows a bootup error UIC 0002. Could you help me please? Thanks a lot. Claudio Balangione. My mail is : cbalangione@hotmail.com
Comprehensive medical imaging support. We supply essential parts & maintenance for most OEMs, buy/sell quality used equipment, and offer mobile rentals globally. Contact us: info@lasoimaging.com
Raphael Cortez
ACUSON ASPEN ADVANCED - ERROR BOOTUP
August 27, 2008 11:27
Hello Friends,
I have a problem with a "Acuson - Aspen Advanced".
When I turn on the equipment appears one message:
BOOTUP ERRORS
UIC ********************* 0002
SCP ********************* 0002
PRESS ANY KEY TO CONTINUE
Please I need of help.
The machine was working good...I move it from the one place for other the machine is bad.
I dont have the service manual of it.
I holp that anybody can help me.
Thanks in advanced.
Bye
to rate and post a comment
marco antonio goncalez
Re: ACUSON ASPEN ADVANCED - ERROR BOOTUP
August 28, 2008 04:04
the spc board probably this with defect, changes to see.
it this in the rack scan that is on the right side of the machine.
to rate and post a comment
Carlos Gutierrez
re: ACUSON ASPEN ADVANCED - ERROR BOOTUP
May 18, 2012 10:32
I solved this problem!! You have to reseat la circuits boards (horizontals). You can also tighten the screws that press that boards side.
to rate and post a comment
NGATTI MWASHIGHADI
re: re: ACUSON ASPEN ADVANCED - ERROR BOOTUP
May 10, 2016 12:01
I also had the same issue, but for me I had to change the SCV board. Just to inquire could you still be having the software of this unit?
to rate and post a comment
Claudio Balangione
re: ACUSON ASPEN ADVANCED - ERROR BOOTUP
June 29, 2012 03:39
Dear Mr Raphael Cortez, I'm in a hurry with an ACUSON ASPEN ADVANCED, there was a short circuit in the connector of soft keys located on the back side of the monitor, after that the system doesn't boot and shows a bootup error UIC 0002. Could you help me please? Thanks a lot. Claudio Balangione. My mail is : cbalangione@hotmail.com
to rate and post a comment