I have problem whit Agfa CR-35.
Oberon cpu board does not boot, with FPGA not Config red led on and target led on.FDD no activity.
Last line in Hiper terminal is:
sys : no network driver specified - skipping this
adcc1_C:\> sys : SCAN_IO_MASTER pcb found and initialized
** sys : SCAN_IO_SLAVE pcb not found - working without
: #### 19:01:19.138 SYS:starting ICN
** WARNING, out of physical memory, searching for at most 1 minute **
I need clearly to check the Oberon CPU Board before replace it.
I don't think that it is broken , after disconect HDD all the same FDD doesn't recognise. And besides using the terminal it is possible to do operations with partition C,D,E.
BMI-PMI services nearly every make, model, and modality through our nationwide team of nearly 200 local service engineers. Flexible contracts, 24/7 remote monitoring, and ISO 13485 certification. www.brownsmedicalimaging.com / 800-701-9729
Tigran Sahakyan
agfa cr-35 oberon cpu boot problem
July 01, 2013 06:09
I have problem whit Agfa CR-35.
Oberon cpu board does not boot, with FPGA not Config red led on and target led on.FDD no activity.
Last line in Hiper terminal is:
sys : no network driver specified - skipping this
adcc1_C:\> sys : SCAN_IO_MASTER pcb found and initialized
** sys : SCAN_IO_SLAVE pcb not found - working without
: #### 19:01:19.138 SYS:starting ICN
** WARNING, out of physical memory, searching for at most 1 minute **
I need clearly to check the Oberon CPU Board before replace it.
Please help me if it is possible.
to rate and post a comment
Lenny Place
re: agfa cr-35 oberon cpu boot problem
July 02, 2013 06:01
sounds like you lost the hard drive
to rate and post a comment
Tigran Sahakyan
re: re: agfa cr-35 oberon cpu boot problem
July 04, 2013 08:40
I don't think that it is broken , after disconect HDD all the same FDD doesn't recognise. And besides using the terminal it is possible to do operations with partition C,D,E.
to rate and post a comment