David, thanks for your reply, maybe not similar,
My problem is Dmax unable to reach up to 3.2, on the 5302 have internal densitometer to do the film calibration, maybe the reading not correct(I got email from Mr. Juan Fumero), cause of failure circuit or dirty surface, I'm new in 5302,anybody know how to open and clean the input sensor module ?. Thanks and best regards
Thanks David, maybe not similar, on the 5302 film density value read by internal densitometer, according Mr. Juan via email that possible the input module dirty or weak sensor, now I'm trying to clean the surface, I'm new on this printer, looking how to reach the input module, hehehe.
Best regards
Ophthalmic-focused expertise in YAG systems including repair, maintenance and calibration handled with precision by trained professionals. Request service • sales@laserlocators.com • 1-877-924-2020
Ronald
Agfa Drystar 5302
November 30, 2012 01:27
Dear expert,
My Drystar 5302 unable to be printed pure black 0%, Dmax reach 2.94 max only, with internal desitometer using XRite 310.
Anybody know how to increase the the Dmax value.
Thanks in advance for your time and helping me.
ronaldliem@yahoo.com
to rate and post a comment
David Guth
re: Agfa Drystar 5302
November 30, 2012 06:12
On a Drystar 3000, I set the minimum density at .1 and maximum at 3.2, for the border I set it artificially at 600. Your 5302 should be similar.
to rate and post a comment
Ronald
re: re: Agfa Drystar 5302
November 30, 2012 10:02
David, thanks for your reply, maybe not similar,
My problem is Dmax unable to reach up to 3.2, on the 5302 have internal densitometer to do the film calibration, maybe the reading not correct(I got email from Mr. Juan Fumero), cause of failure circuit or dirty surface, I'm new in 5302,anybody know how to open and clean the input sensor module ?. Thanks and best regards
to rate and post a comment
Ronald
re: re: Agfa Drystar 5302
November 30, 2012 10:02
Thanks David, maybe not similar, on the 5302 film density value read by internal densitometer, according Mr. Juan via email that possible the input module dirty or weak sensor, now I'm trying to clean the surface, I'm new on this printer, looking how to reach the input module, hehehe.
Best regards
to rate and post a comment