if you only have the service manual, it is not enough, you must
get the service software to connect the machine and diagnostic
and test it, i have all service manuals and service
software,install software of AGFA DRY3000, if you need any help,
please contact obnauy@163.com
Error Code --> 6c841
E_T14_S8_MALFUNCTION,
Meaning : During a drum-calibration only a single
encoder-readout has been obtained. This is
not correct. A malfunction caused this
error-condition.
Reason : Possible malfunction or disconnection of
the drum-(slit-)sensor . As a result, since
no sensor-transitions are spotted, only a single
encoder read-out has been spotted.
Cure : a. Check sensor s8.
b. Replace the sensor.
c. Check the wirings.
d. Check the PMC-board functioning and release stamps.
Sometimes, we have the same error, but after off/on, it's ok.
I had the same error and we have fixed ours. solution: Just replace the larger belt located on the left side of the printer. That's all we did and it resolved our problem. Goodluck.
Dale Lumbra
AGFA DS 3000 ERROR 6C841
October 20, 2010 01:11
I AM HAVING AN ISSUE ON BOOT UP SYSTEM COMING UP WITH ERROR 6C841 SOUNDS LIKE BAD SENSOR BUT WHICH ONE ANY HELP APPRECIATED.
to rate and post a comment
yuan bo
Re: AGFA DS 3000 ERROR 6C841
October 21, 2010 09:34
if you only have the service manual, it is not enough, you must
get the service software to connect the machine and diagnostic
and test it, i have all service manuals and service
software,install software of AGFA DRY3000, if you need any help,
please contact obnauy@163.com
to rate and post a comment
- -
Re: AGFA DS 3000 ERROR 6C841
October 22, 2010 07:51
6C841
Error Code --> 6c841
E_T14_S8_MALFUNCTION,
Meaning : During a drum-calibration only a single
encoder-readout has been obtained. This is
not correct. A malfunction caused this
error-condition.
Reason : Possible malfunction or disconnection of
the drum-(slit-)sensor . As a result, since
no sensor-transitions are spotted, only a single
encoder read-out has been spotted.
Cure : a. Check sensor s8.
b. Replace the sensor.
c. Check the wirings.
d. Check the PMC-board functioning and release stamps.
Sometimes, we have the same error, but after off/on, it's ok.
to rate and post a comment
Thomas Onyema
Re: AGFA DS 3000 ERROR 6C841
October 29, 2010 11:44
Have you been able to fix this error?
to rate and post a comment
Thomas Onyema
Re: AGFA DS 3000 ERROR 6C841
November 08, 2010 11:23
I had the same error and we have fixed ours. solution: Just replace the larger belt located on the left side of the printer. That's all we did and it resolved our problem. Goodluck.
to rate and post a comment