I ve got an Ultrasound Aloka SSD-900, its been not in use for about a year now when i switched on the unit it could have a graphic display or normal when the probe is connected but the date and the rest of display like probe type, hospital name could not be displayed, so i thought its the battery and i left it on charging for 24 hours.
I checked the battery and it was with 3.9V which is ok but now the monitor does not display anything at all although the power LED is lit.
Did you solve this issue? I have the same problem.
Does anybody knows which voltag levels must be on the power supply? I measured +5, -5, 15, -15, 40 and 23.4V with the power supply connected and disconnected from the equipment.
HIGH QUALITY fully tested & refurbished systems to manufacturer specifications like new. Installation & service support worldwide. Parts & tubes in stock with warranty. Sales@Elsmed.com
ROMAN KASIRYE
Aloka SSD-900 technical problems
March 13, 2009 06:17
Dear all,
I ve got an Ultrasound Aloka SSD-900, its been not in use for about a year now when i switched on the unit it could have a graphic display or normal when the probe is connected but the date and the rest of display like probe type, hospital name could not be displayed, so i thought its the battery and i left it on charging for 24 hours.
I checked the battery and it was with 3.9V which is ok but now the monitor does not display anything at all although the power LED is lit.
What is the problem??
Roman
to rate and post a comment
Thomas Vella
Re: Aloka SSD-900 technical problems
March 13, 2009 08:44
tom vella
hydracomp@aol.com
516-528-2250
to rate and post a comment
ROMAN KASIRYE
Re: Aloka SSD-900 technical problems
March 15, 2009 05:02
Hello Tom,
Any solution to this problem?
Roman
to rate and post a comment
habib sheikhottayefeh
Re: Aloka SSD-900 technical problems
May 18, 2009 04:46
I think you have to reset the machine to default manufacturer datas.
Regards, Habib
to rate and post a comment
Luis Togo
Re: Aloka SSD-900 technical problems
May 22, 2009 02:11
Hello Roman:
Did you solve this issue? I have the same problem.
Does anybody knows which voltag levels must be on the power supply? I measured +5, -5, 15, -15, 40 and 23.4V with the power supply connected and disconnected from the equipment.
Thanks
Luis
to rate and post a comment