I have installed 3 units of AFP 3000SV, almost the same problem occurs;the developed film result was quite dry. I'm done cleaning all rollers of the developer, fixer and water but the same problem occur.
Possible solutions or suggestions are highly welcome!
Re: Automatic Film Microprocessor (3000SV) Problem
June 12, 2005 12:58
hi ramil cortes
you say that developed films are quite dry, so i think you mean that films are hot at the exit of developer machine; in this case it is just matter of calibrating dryer temperature.
good luck
jasg
Re: Automatic Film Microprocessor (3000SV) Problem
June 20, 2005 09:11
thanks for the reply..
you said that "films are hot at the exit of developer machine..and in this case it's just matter of calibrating dryer temperature" u mean i need to adjust the developer heater, how would i calibrate it to decrease the temperture?
Sell your scrap MRI magnets! Top prices, free shipping, and fast pickups. Don't let dust-collecting, idle assets go to waste. Contact: ryan.swiderski@cyclicmaterials.earth or call 437-826-1621
Ramil Cortes
Automatic Film Microprocessor (3000SV) Problem
June 06, 2005 01:03
I have installed 3 units of AFP 3000SV, almost the same problem occurs;the developed film result was quite dry. I'm done cleaning all rollers of the developer, fixer and water but the same problem occur.
Possible solutions or suggestions are highly welcome!
thanks!
to rate and post a comment
JOSE ANTONIO SANCHEZ GALVAN
Re: Automatic Film Microprocessor (3000SV) Problem
June 12, 2005 12:58
hi ramil cortes
you say that developed films are quite dry, so i think you mean that films are hot at the exit of developer machine; in this case it is just matter of calibrating dryer temperature.
good luck
jasg
sagarx@prodigy.net.mx
to rate and post a comment
Ramil Cortes
Re: Automatic Film Microprocessor (3000SV) Problem
June 20, 2005 09:11
thanks for the reply..
you said that "films are hot at the exit of developer machine..and in this case it's just matter of calibrating dryer temperature" u mean i need to adjust the developer heater, how would i calibrate it to decrease the temperture?
thanks for ur time...
to rate and post a comment