I got throubles on GE Brightspeed on XRay ON, using 100MA or more
60-313 Inverter Max IRL or
69-318 kV did not reach 75 %
I tested inverter Short circuit OK, Rotor and Heater OK too
Any suggest about solve this problem
Thank you
My sugestión. Try NOLOAD KV TEST with TUBE cable phisically desconnected from hv thank to test this Ãtem individualy, then verifie the imoedance of hv cable pin to pin betwen both sides.
According to the results the problem could be HV TANK, cable or TUBE.
Regards
Lightly used system available direct from the end user customer. MONARCH QUEST
Featuring our most advanced, data-driven navigation software with AI-Powered algorithms & advanced imaging integration with the GE HealthCare OEC 3D C-arm.
Brightspeed HV ERROR
February 23, 2017 10:24
I got throubles on GE Brightspeed on XRay ON, using 100MA or more
60-313 Inverter Max IRL or
69-318 kV did not reach 75 %
I tested inverter Short circuit OK, Rotor and Heater OK too
Any suggest about solve this problem
Thank you
to rate and post a comment
Mateo Barloqui
re: Brightspeed HV ERROR
February 24, 2017 10:37
Hi, how are You?
According to what you say your problem in the HV tank. You would confirm it testing No Load kV!
I hope that this helps you! Regards
to rate and post a comment
Brent Hull
re: Brightspeed HV ERROR
February 26, 2017 02:35
I have seen this error on a BrightSpeed 4. The fix was to replace the heater board.
to rate and post a comment
Brent Hull
re: Brightspeed HV ERROR
February 26, 2017 02:36
I have had this problem. Replace the Heater board.
to rate and post a comment
Ruben Cadima
re: Brightspeed HV ERROR
February 26, 2017 02:36
My sugestión. Try NOLOAD KV TEST with TUBE cable phisically desconnected from hv thank to test this Ãtem individualy, then verifie the imoedance of hv cable pin to pin betwen both sides.
According to the results the problem could be HV TANK, cable or TUBE.
Regards
to rate and post a comment
CRAIG WAMBURA
re: Brightspeed HV ERROR
February 27, 2017 10:43
perform KV Loop Test and KV MA meter checks to isolate the HV cables and HV Tank/Inverter.
to rate and post a comment