Hi colleagues
I have this philips brilliance 16 with so many artifacts and noise in the helical reconstruction images. I realized that the problem was the 3DBP Board, cause the diagnostic 3dbp didnt pass, but when i was installing the new 3dbp board I Realized that 2 ram memories (1gb each) of 4, where bad. So, i tried using 2 rams of 2gb each, but after an hour the Adquisition Board was not recognized by windows and couldnt install the driver.
Message "Device cant start"" Code 10" appears on the device manager. I restarted the system, reinstall the board but cant install the board, seems like dead, no lights on it neither.
Please, any help and suggestion would be helpful.
It would be very helpful to me if someone could send me the brilliance 16 service manuals and error codes and solutions. Best regards
If you know how to configure cirs to edit that it works only with one server please tell me how. I know is editing a register with number of server but dont know where is it.
We are the best choice for all your Endoscopy needs. We have Certified Pre-Owned refurbished and used Endoscopes, and all other related components and
accessories. We are committed to your absolute satisfaction. (513) 469-7267
Primco
Brilliance 16 CIRS problem
June 15, 2013 07:31
Hi colleagues
I have this philips brilliance 16 with so many artifacts and noise in the helical reconstruction images. I realized that the problem was the 3DBP Board, cause the diagnostic 3dbp didnt pass, but when i was installing the new 3dbp board I Realized that 2 ram memories (1gb each) of 4, where bad. So, i tried using 2 rams of 2gb each, but after an hour the Adquisition Board was not recognized by windows and couldnt install the driver.
Message "Device cant start"" Code 10" appears on the device manager. I restarted the system, reinstall the board but cant install the board, seems like dead, no lights on it neither.
Please, any help and suggestion would be helpful.
It would be very helpful to me if someone could send me the brilliance 16 service manuals and error codes and solutions. Best regards
to rate and post a comment
angel Edward ciriaco Durán
re: Brilliance 16 CIRS problem
May 10, 2016 04:50
Need documentation please email me starki.arq@gmail.com
to rate and post a comment
angel Edward ciriaco Durán
re: Brilliance 16 CIRS problem
June 23, 2016 02:24
If you know how to configure cirs to edit that it works only with one server please tell me how. I know is editing a register with number of server but dont know where is it.
to rate and post a comment