that machine makes a lot of check when is on and then if something is not correct doesnt allow make x ray ,that could be aperture limit switch ,generator no ready ,work station not ready or disconected could be too much reason but the effect is the same...check those parts... regards joel
thanks that is true, actually the machine is on and all is ok whe try to have flouro kv an ma try to have a image but is dark yet. I check all and the principal obs is a HEF4534BP in SE15 is so hot. Now I am wait for change this part to check again.
in the display all show ok and in the error window only appear "error min" without any number.
Yojin Ramones
Bv 25 C arm problem
July 19, 2007 06:23
Hi my friend
the C arm when is on look weel but apear "Error min" and after a time start flash a light led ON.
I cant shoot any Rx.
on display number is 140 KV and 1.2
Ma in fluoro mode and diafram not work
sugest I will apreciated
regards
yojinRamones
to rate and post a comment
Joel Grullon
Re: Bv 25 C arm problem
July 31, 2007 04:11
that machine makes a lot of check when is on and then if something is not correct doesnt allow make x ray ,that could be aperture limit switch ,generator no ready ,work station not ready or disconected could be too much reason but the effect is the same...check those parts... regards joel
to rate and post a comment
Yojin Ramones
Re: Bv 25 C arm problem
July 31, 2007 05:36
thanks that is true, actually the machine is on and all is ok whe try to have flouro kv an ma try to have a image but is dark yet. I check all and the principal obs is a HEF4534BP in SE15 is so hot. Now I am wait for change this part to check again.
in the display all show ok and in the error window only appear "error min" without any number.
Well I will apreciated your coments
regards
yojin ramones
to rate and post a comment