BV Libra IP address issue, can't access with BV-Scope
March 02, 2015 09:13
Trying to pair a MVS and C-Arm stand. IST and Philips dongle are good to go.
I've done this before and the service IP address has always been 192.168.1.61.
On this system (DFI swapped with another Libra), the service IP is displayed as 192.100.10.33...
BV-Scope fails to reach target on both IP addresses. Neither address successfully pings in cmd
When this DFI was in another MVS, I remember connecting with BV-Scope.
what about that dfi when you return it? Is it still run or not? if yes, you have to enable service mode on Mvs'monitor and then connect it. Maybe you forgot this step.
re: BV Libra IP address issue, can't access with BV-Scope
March 03, 2015 10:30
Attach a ethernet switch or anoter active network cable to the network port of the Libra or Pulsera before turning the C-arm workstation on. If during boot the workstation doesn't sense an active connection , it disables the network port. Atleast that has been my experience with it.
re: BV Libra IP address issue, can't access with BV-Scope
March 03, 2015 06:09
On both Libras, the IP addresses changed. The only common thing is my laptop, which I find extraordinary.
I forgot to switch my IP address to this new one on my laptop. I was able to get in to both systems.
Still finding it bizarre
BMI-PMI services nearly every make, model, and modality through our nationwide team of nearly 200 local service engineers. Flexible contracts, 24/7 remote monitoring, and ISO 13485 certification. www.brownsmedicalimaging.com / 800-701-9729
Sang
BV Libra IP address issue, can't access with BV-Scope
March 02, 2015 09:13
Trying to pair a MVS and C-Arm stand. IST and Philips dongle are good to go.
I've done this before and the service IP address has always been 192.168.1.61.
On this system (DFI swapped with another Libra), the service IP is displayed as 192.100.10.33...
BV-Scope fails to reach target on both IP addresses. Neither address successfully pings in cmd
When this DFI was in another MVS, I remember connecting with BV-Scope.
Any insight would be appreciated
to rate and post a comment
Wo Thing
re: BV Libra IP address issue, can
March 03, 2015 10:11
Hi sang.
what about that dfi when you return it? Is it still run or not? if yes, you have to enable service mode on Mvs'monitor and then connect it. Maybe you forgot this step.
to rate and post a comment
Thomas Williams
re: BV Libra IP address issue, can't access with BV-Scope
March 03, 2015 10:30
Attach a ethernet switch or anoter active network cable to the network port of the Libra or Pulsera before turning the C-arm workstation on. If during boot the workstation doesn't sense an active connection , it disables the network port. Atleast that has been my experience with it.
to rate and post a comment
Sang
re: BV Libra IP address issue, can't access with BV-Scope
March 03, 2015 06:09
On both Libras, the IP addresses changed. The only common thing is my laptop, which I find extraordinary.
I forgot to switch my IP address to this new one on my laptop. I was able to get in to both systems.
Still finding it bizarre
to rate and post a comment