Now, i'm meeting a problem with CT AURA PHILIPS, So anyone have much experience about this system, please spend a litle time to help me.
The symptoms with it as following:
* After the tube is warmed-up, I did "Air Calibration". Sometime this procedure could be done, sometime The system generates: "Error detected". And in "feerrlog" appears error message: "BASE - Communication error (RF Trigger)". When the error was issued, the system couldn't do "Air Calibration" again.
* Sometime this error message appeared during warm-up.
* When the system is be re-started, all procedures could do again but the system still meets above symptoms.
Please give me some advices to find-out the causes.
Hien Dao
Communication error (RF Trigger)PHILIPs CT Aura
October 17, 2007 10:33
Now, i'm meeting a problem with CT AURA PHILIPS, So anyone have much experience about this system, please spend a litle time to help me.
The symptoms with it as following:
* After the tube is warmed-up, I did "Air Calibration". Sometime this procedure could be done, sometime The system generates: "Error detected". And in "feerrlog" appears error message: "BASE - Communication error (RF Trigger)". When the error was issued, the system couldn't do "Air Calibration" again.
* Sometime this error message appeared during warm-up.
* When the system is be re-started, all procedures could do again but the system still meets above symptoms.
Please give me some advices to find-out the causes.
Thank you,
to rate and post a comment