After formating all HDDs in RDD and Image disk initialization
any attempt to scan (Air Calibr, NRA, patient scan) leads
to the following error message:
An abnormal scan conditions was found.
Please restart the exam plan.
code [0xc0900011] dev[0x00140000] Pno [1]
Warm up could be done with no problem.
When scan starts the gatry makes one or more
rotations, starts x-ray explosion and stops
with the above message.
No disk has been replaced. RDDUtil says that all disks are good. When we try to Reconfigure RDD with parity the system says that the RTM is not ready and waits too much time...
Comprehensive medical imaging support. We supply essential parts & maintenance for most OEMs, buy/sell quality used equipment, and offer mobile rentals globally. Contact us: info@lasoimaging.com
Alexandr Reuta
CT Activion 16 scan problem
June 14, 2012 04:37
Dear friends,
This is an Activion 16.
After formating all HDDs in RDD and Image disk initialization
any attempt to scan (Air Calibr, NRA, patient scan) leads
to the following error message:
An abnormal scan conditions was found.
Please restart the exam plan.
code [0xc0900011] dev[0x00140000] Pno [1]
Warm up could be done with no problem.
When scan starts the gatry makes one or more
rotations, starts x-ray explosion and stops
with the above message.
Any suggestion is appreciated
Alex
reutaav@inbox.ru
to rate and post a comment
Gee Gicale
re: CT Activion 16 scan problem
June 14, 2012 05:59
Hi, Did you replaced 1 rdd disk or more? Have you tried Reconfigure RDD with parity.
to rate and post a comment
Alexandr Reuta
re: re: CT Activion 16 scan problem
June 15, 2012 09:44
Thank you for your answer
No disk has been replaced. RDDUtil says that all disks are good. When we try to Reconfigure RDD with parity the system says that the RTM is not ready and waits too much time...
to rate and post a comment
Gee Gicale
re: re: re: CT Activion 16 scan problem
June 15, 2012 03:25
Reconfigure RDD takes a lot of time, it ranges from 45 to 85 minutes. Try doing that again, hopefully you'll get a message " Rdd done"
to rate and post a comment
Alexandr Reuta
re: re: re: re: CT Activion 16 scan problem
June 17, 2012 09:44
Thank you very much! We will try...
to rate and post a comment
Jun Fang
re: CT Activion 16 scan problem
June 15, 2012 09:42
Some of the MHR pwb maybe broken, use the MHR diagnostic program to identify which is the bad one
to rate and post a comment
Alexandr Reuta
re: re: CT Activion 16 scan problem
June 17, 2012 09:44
Thank you very much for your support! We will try this.
to rate and post a comment
Anton Spaci
re: CT Activion 16 scan problem
June 30, 2012 11:43
access of RDD is not good
MHR FC could be faulty
to rate and post a comment
Alexandr Reuta
re: re: CT Activion 16 scan problem
July 01, 2012 09:07
thank you very much for your reply!
The problem was ubnormal currents from the generator.
RDD & PCBs are Ok
to rate and post a comment