we are having problem in CTI. The errors are as below:-
Diagnostic command was received before diagnostic were initialized 212017
unable to reset scanning hardware 212076
Error Trace back 96509
The rest failure of OBC may be due to reset failure of STC 244554
STC Failure 244553
Failed to establish socket connection in 10 seconds 178568
hope somebody can help us in locating the problem.
Online auction of modern high-end laboratory and biopharma research equipment from the recent bankruptcy of Spexis AG in Allschwil near Basel, Switzerland. Start bidding today! closes on June 4. info@dome-auctions.com..+31(0)20 808 2880
S Goyal
CTI Problem
June 23, 2006 03:14
we are having problem in CTI. The errors are as below:- Diagnostic command was received before diagnostic were initialized 212017 unable to reset scanning hardware 212076 Error Trace back 96509 The rest failure of OBC may be due to reset failure of STC 244554 STC Failure 244553 Failed to establish socket connection in 10 seconds 178568 hope somebody can help us in locating the problem.
to rate and post a comment
Scott Anderson
Re: CTI Problem
July 14, 2006 07:43
Did you find out the problem?
to rate and post a comment
S Goyal
Re: CTI Problem
July 15, 2006 04:16
yes. we could correct the problem.
to rate and post a comment
farhan zeb
Re: CTI Problem
September 17, 2011 07:06
INDIGO2 4.4 version
1_) dear friend i have loaded the software first i loaded the OS then
Applications and after that i have to configure or load the SBC with OC when i type the command loadSBC so the
following error occurs Not enough free spcae can not load network software
when i try to connect to SBC i type the command cu sbc but following error occured connect failed: cant't access
device
i have tried all the procedure from LFC but still same problem i have tried to bring it to the MC6080> prompt but
still nothing happened still same problem
but when i use the command rsh sbc and reconfig the sbc and after st so during initialization system goes shut down
itself .
NOTE:
when i have loaded the application software so after that when i open the unix shell so an message
appeared executing install.dasm no dasm's found
so please help me i'll wait for your reply
2_) Dear friend i have lost the system state also of cti indigo2 system and and the oc disk drive have been crashed
i have
replace the disk drive and loaded the software from cold so i have lost my system state so now i have loaded the
software but i have no system state but there is need of the system state so what should i do now there is the
method to restore files in the LFC but how should i access the unix shell with crash disk drive so please tell me
what will be the alternative way to skip this step and start the applications.
to rate and post a comment