Can anybody help me with trobleshooting one?
I have a message on control panel "Capacitor charging time out of tolerance".
But in addition, I haven't service program and manual.
Hi Vladimir!
If this is X-Ray maschine, my apinion is - check Generator supply - Charging block. In sam system this charging block can produced 1500V for Inverter. Or Generator have soft charging circuit and relay (connect power directly to capacitor bank after charging finished). Fuses, relay or management.
If You will good answer, giwe please more information (type or modell, indication inside generator, board names and etc ....).
Uldis
DirectMed Imaging specializes in Equipment Sales, Parts, and Support. Parts are in stock and available for immediate delivery. In-room MRI Upgrades are available now. (855) 463-3727 or sales@directmedimaging.com
Vladimir Vladimirov
Dornier Gemini
March 27, 2018 04:22
Hello there!
Can anybody help me with trobleshooting one?
I have a message on control panel "Capacitor charging time out of tolerance".
But in addition, I haven't service program and manual.
familirov@gmail.com
to rate and post a comment
Uldis Verdins
re: Dornier Gemini
March 28, 2018 09:00
Hi Vladimir!
If this is X-Ray maschine, my apinion is - check Generator supply - Charging block. In sam system this charging block can produced 1500V for Inverter. Or Generator have soft charging circuit and relay (connect power directly to capacitor bank after charging finished). Fuses, relay or management.
If You will good answer, giwe please more information (type or modell, indication inside generator, board names and etc ....).
Uldis
to rate and post a comment