Hello everyone, from one QA to another from all pass to different fail. DPX-MD ver 4.7e. The graph very bad,I verified aligned are ok, I changed the detector getting some values decrease to a normal values but both curves on graphs moves back or forward when change the voltage on SBC board, but always separates not reach join it.
Any idea? I have some QA if neccesary
Eduardo
I thought you had resoved all your issues. Try emailing me again. Do you have a service manual? Your proplem is the voltage setting on your SBC board. AJ Garry
Dear Eduardo,
Now you have probably confused.
From the wrong position of "standard" (black phantom) to count ajustment( ajustment of SBC), wrong transvarse or fault HVPS, changes on alignment, solenoid assy etc you may have incorrect curves on QA test and various values failed.
I suggest you to send me a copy of one old correct QA test and some of the failed ones. It may be just an ajustment.
BMI-PMI services nearly every make, model, and modality through our nationwide team of nearly 200 local service engineers. Flexible contracts, 24/7 remote monitoring, and ISO 13485 certification. www.brownsmedicalimaging.com / 800-701-9729
DPX-MD
March 14, 2013 12:17
Hello everyone, from one QA to another from all pass to different fail. DPX-MD ver 4.7e. The graph very bad,I verified aligned are ok, I changed the detector getting some values decrease to a normal values but both curves on graphs moves back or forward when change the voltage on SBC board, but always separates not reach join it.
Any idea? I have some QA if neccesary
Eduardo
to rate and post a comment
Ben Williams
re: DPX-MD
March 14, 2013 05:19
Hi Eduardo, feel free to email me your QA's. I can take a look and see if I can help. ben@dexasolutions.com
to rate and post a comment
Desmond Johnson
re: DPX-MD
March 14, 2013 06:12
Most likely the upper or lower cable bundle wires for the DC voltages to the PMT Bias Power Supply.
to rate and post a comment
Cristiano Canova
re: DPX-MD
March 14, 2013 11:22
Try to replace the high voltage supplies, positive or negative. This will solve the problem.
to rate and post a comment
ALEXANDER PILAFTSIS
re: DPX-MD
March 15, 2013 09:04
eduardo it can be everything of the above and some more. Send me your QA tests.
to rate and post a comment
Manuel Casanova
re: DPX-MD
March 15, 2013 10:40
PLEASE SEND ME QA FILES FOR SUPPORT, semmedical@gmail.com
to rate and post a comment
Manuel Casanova
re: DPX-MD
March 15, 2013 10:40
SEND ME QA IF YOU NEED THE PARTS, SERVICE MANUALS CONTACT ME
to rate and post a comment
Albert J. GARRY
re: DPX-MD
March 15, 2013 12:39
Hello Eduardo,
I thought you had resoved all your issues. Try emailing me again. Do you have a service manual? Your proplem is the voltage setting on your SBC board. AJ Garry
to rate and post a comment
ALEXANDER PILAFTSIS
re: DPX-MD
March 15, 2013 09:41
Dear Eduardo,
Now you have probably confused.
From the wrong position of "standard" (black phantom) to count ajustment( ajustment of SBC), wrong transvarse or fault HVPS, changes on alignment, solenoid assy etc you may have incorrect curves on QA test and various values failed.
I suggest you to send me a copy of one old correct QA test and some of the failed ones. It may be just an ajustment.
to rate and post a comment