Hello dear colleagues!
I have a DRYPIX 2000 that do not full initialize, somewhere it stuck and shows "Corporation IL-0" on the LCD. Meanwhile on the PC I am getting an Printer error. I have seen all the sensors, but does not find anything caused this problem.
Could somebody help to find solution for this issue, or any service manual for this device?
Any kind of help shall be much appreciated.
Lightly used system available direct from the end user customer. MONARCH QUEST
Featuring our most advanced, data-driven navigation software with AI-Powered algorithms & advanced imaging integration with the GE HealthCare OEC 3D C-arm.
Fredi Panci
DRYPIX 2000
March 17, 2011 09:56
Hello dear colleagues!
I have a DRYPIX 2000 that do not full initialize, somewhere it stuck and shows "Corporation IL-0" on the LCD. Meanwhile on the PC I am getting an Printer error. I have seen all the sensors, but does not find anything caused this problem.
Could somebody help to find solution for this issue, or any service manual for this device?
Any kind of help shall be much appreciated.
to rate and post a comment
ali hashemyan
re: DRYPIX 2000
June 26, 2013 10:38
hello
u must reinstal software on CF card of printer
to rate and post a comment
coldstar
re: re: DRYPIX 2000
July 02, 2013 07:05
yes ,the systerm software in cf card is bad.
to rate and post a comment
coldstar
re: DRYPIX 2000
July 02, 2013 07:05
hello,what you said is the system software in cf card is bad.
to rate and post a comment
coldstar
re: DRYPIX 2000
July 02, 2013 07:05
hello,what you said is the system software in cf card is bad.
to rate and post a comment