efilm configuration with agfa printers

More to it than that

There is more to setting up the printer in efilm than just adding the ip address and ae title unlike what other individuals are telling you.

Get the IP address and AE title from the printer, port will be 104. Go to keypad of the printer and show info, from there IP address, AE and port will be accessible.

Open efilm and go to Edit, then open the Dicom Printers tab.
Bottom section under Device create an alias or Description. Call it AXYS
AE Title: enter the AE of the printer, might be AXYS but you can find it from the key pad under show info.

IP Address: enter IP address of printer
Port: enter 104
Format: Standerd \1,1 (this means it will be a 1x1 format.
Priority: medium
Medium: Depending on what your film is if it's DT2B set it as Blue
If it's DT2C set it as clear.
Copies: set as 1
Film Orientation: set as Portrait
Film Size: depends on what you have in the drawers, if you want to only print on 14x17 set 14INx17IN
Film Destination: set as Processor
Resolution: set as 300
Magnification: set as Cubic
Smoothing: set as Medium
Trim: set as Yes
Densities section
Min: set as 0
Border: Black
Max: 300 (this is the d-max of the printer)
Empty: 300
Click Add
Then click: Verify
If it's successful it will verify, if not double check your ip address and ae title.
If you need to make changes to the printer highlight it from your list make the necessary changes and click update.