Error Code --> 6c4a2
E_T14_VMEAS_THREF,
Meaning : Error in determining min/max of power-supply.
Difference between min/max-read-out of
power-supply is too small.
Reason : a. ADC-cycle fails.
b. Connector allowing PWM-voltage control
is broken or not inserted.
Cure : a. Check resource-status -> AIC-board.
b. Check cable(s) to power-supply.
JAOZAFY Aly Johnny
Error 6C4A2 on AGFA Dr3000
January 27, 2012 10:21
Erreur 6C4A2 apparaît au démarrage de l'imprimante pendant la séquence d'initialisation.
Carte AIC1 Rev -H - N/S 03230H :
Led1 Led2 Led3 VCC -VS +Vs
OFF OFF ON ON ON ON
Vth PWM
ON ON
Carte PMC1 Rev H - N/S 304K0447
L1 L2 L3 L4 L5 L6
ON OFF Flash Flash Flash ON
L7 Heater +5V +8V +12V -12V
ON OFF ON ON ON ON
+24V
ON
GEMINI Board
OFF OFF OFF
ON Flash OFF
OFF OFF OFF
Flash OFF OFF
COS Board
vert jaune Rouge
OFF OFF OFF
OFF OFF OFF
OFF ON ON
Led2 Led5 Led6 Led7
OFF OFF OFF OFF
ALIMENTATION :
Les 6 Leds vertes = ON
COMMENT FAIRE?
to rate and post a comment
Jose Victor Perez Losada
Re: Error 6C4A2 on AGFA Dr3000
January 27, 2012 05:35
Hello, please contact me in vplosada@gmail.com
Regards
to rate and post a comment
Dante Nuevo
Re: Error 6C4A2 on AGFA Dr3000
January 30, 2012 10:23
Error Code --> 6c4a2
E_T14_VMEAS_THREF,
Meaning : Error in determining min/max of power-supply.
Difference between min/max-read-out of
power-supply is too small.
Reason : a. ADC-cycle fails.
b. Connector allowing PWM-voltage control
is broken or not inserted.
Cure : a. Check resource-status -> AIC-board.
b. Check cable(s) to power-supply.
I hope it helps you.
Dante Nuevo
to rate and post a comment