I need help regarding the Eschmann RX500 OT Table.
I got some problem that I go through with this machine :
1 - the motor keep running after I put in the Fuse even though without turn on the switch.
2 - there's got 12 function for the rx500 from the remote control. but when I follow the exact polarity, only half of the function can be run. and if i reverse the polarity, the other half function can be use, vice versa. how this can be happen ?
can anyone give some idea for this matter because i tried everything already. i check all the voltage and continuity everything is good. is it because of the relay ? or what can cause this problem.
Lightly used system available direct from the end user customer. MONARCH QUEST
Featuring our most advanced, data-driven navigation software with AI-Powered algorithms & advanced imaging integration with the GE HealthCare OEC 3D C-arm.
Muhammad Luqman
Eschmann RX500
March 04, 2021 11:32
Good day,
I need help regarding the Eschmann RX500 OT Table.
I got some problem that I go through with this machine :
1 - the motor keep running after I put in the Fuse even though without turn on the switch.
2 - there's got 12 function for the rx500 from the remote control. but when I follow the exact polarity, only half of the function can be run. and if i reverse the polarity, the other half function can be use, vice versa. how this can be happen ?
can anyone give some idea for this matter because i tried everything already. i check all the voltage and continuity everything is good. is it because of the relay ? or what can cause this problem.
hope you guys can give me some advise. thank you.
to rate and post a comment