It is needed to login as config (contact me for password) and then define new node and the device on this node.
You need to configure Name, IP and port number. For configuration it is needed to know type of communication (Send to or Send and Receive).
It is recommended to have PACS IP in the same class. Port Dicom default is 104 but can be different
Login as Config (pass config95) and there you can change all the Network and DICOM configs and add new nodes. Be carefull, the DICOM Printers and DICOM nodes have EATitles case sensitive. DON'T CHANGE ANYTHINNG on Local or Pro labels or the CT will not work again !
Good Luck!
Lightly used system available direct from the end user customer. MONARCH QUEST
Featuring our most advanced, data-driven navigation software with AI-Powered algorithms & advanced imaging integration with the GE HealthCare OEC 3D C-arm.
juan pablo amado
Eslcint select sp dicom node
August 12, 2015 10:29
Looking info about adding new (pacs ) dicom node in system config,
to rate and post a comment
Wojciech Selwesiuk
re: Eslcint select sp dicom node
August 13, 2015 02:49
It is needed to login as config (contact me for password) and then define new node and the device on this node.
You need to configure Name, IP and port number. For configuration it is needed to know type of communication (Send to or Send and Receive).
It is recommended to have PACS IP in the same class. Port Dicom default is 104 but can be different
to rate and post a comment
Gustavo Volpi
re: Eslcint select sp dicom node
August 16, 2015 11:41
Login as Config (pass config95) and there you can change all the Network and DICOM configs and add new nodes. Be carefull, the DICOM Printers and DICOM nodes have EATitles case sensitive. DON'T CHANGE ANYTHINNG on Local or Pro labels or the CT will not work again !
Good Luck!
to rate and post a comment