Dear Colleagues! I am having a problem for Ge Advantx tilt c positioner system PRD error. The CPU board's 2 digit error display shows 50 and then shows 56 on the power on. This error started after the table hit the x-ray tube head in an accident. What does this mean? I could get error codes up to 46 and then from 60 onwards. But I could not find the 50 to 59 in the diagnostics manual. If anyone knows what this means your help is very much solicited
PRD of the Tilt-C CPU bd. or the PRD of the Advantx-E (or Advantx-1) CPU bd??? Once the collision had occurred,the only movement allowed should be reverse or out of the collision. If only some movements are allowed you may need to turn off the limits to allow any and all movement, but this will allow you to get into worse situation as well. Verify all collision sensors have been released (two spring and cable activated switches in the tube port cover).
shayward@sodexoctm.com
BMI-PMI services nearly every make, model, and modality through our nationwide team of nearly 200 local service engineers. Flexible contracts, 24/7 remote monitoring, and ISO 13485 certification. www.brownsmedicalimaging.com / 800-701-9729
JIFFY PAUL AKKARAKARAN
GE Advantx tilt c positioner PRD error code
March 15, 2011 05:38
Dear Colleagues! I am having a problem for Ge Advantx tilt c positioner system PRD error. The CPU board's 2 digit error display shows 50 and then shows 56 on the power on. This error started after the table hit the x-ray tube head in an accident. What does this mean? I could get error codes up to 46 and then from 60 onwards. But I could not find the 50 to 59 in the diagnostics manual. If anyone knows what this means your help is very much solicited
to rate and post a comment
Staate Hayward
Re: GE Advantx tilt c positioner PRD error code
March 16, 2011 04:22
PRD of the Tilt-C CPU bd. or the PRD of the Advantx-E (or Advantx-1) CPU bd??? Once the collision had occurred,the only movement allowed should be reverse or out of the collision. If only some movements are allowed you may need to turn off the limits to allow any and all movement, but this will allow you to get into worse situation as well. Verify all collision sensors have been released (two spring and cable activated switches in the tube port cover).
shayward@sodexoctm.com
to rate and post a comment