Type your Dear All
System: GE C-arm OEC FLUOROSTAR 750
I facing a problem :
After booting, this system displays the following error: '' Version number problems have been detected possible causes: Hardware modules have been replaced or are defective
-the software update failed the problem concerns: B380 B356 ''
- I checked the version of SW and HW: '' Current B356: 0.00 expected: 6.052
-I reset the system no error is displayed.
When I do a ââfluoroscopieââ, the system displays the error '' unlock the system with the key switch '', and yet on this system there is no key.
Would-you please give me advice to solve this problem.
question or comment here...
Specializing in GE, we keep your ICU monitors calibrated and patient-ready—fast, reliable service from expert biomed techs. Southeastern Biomedical: 888-310-7322.
Philbest
GE C-ARM
January 23, 2017 08:07
Type your Dear All
System: GE C-arm OEC FLUOROSTAR 750
I facing a problem :
After booting, this system displays the following error: '' Version number problems have been detected possible causes: Hardware modules have been replaced or are defective
-the software update failed the problem concerns: B380 B356 ''
- I checked the version of SW and HW: '' Current B356: 0.00 expected: 6.052
-I reset the system no error is displayed.
When I do a ââfluoroscopieââ, the system displays the error '' unlock the system with the key switch '', and yet on this system there is no key.
Would-you please give me advice to solve this problem.
question or comment here...
to rate and post a comment
ClarityDiagnostics
re: GE C-ARM
January 23, 2017 05:04
Have you tried to reload the application software?
to rate and post a comment
Philbest
re: re: GE C-ARM
January 25, 2017 05:50
No; because I don't have SW but,is there a method to do a SW test?
thank you for your support
to rate and post a comment