LogiQ would not boot,the DVD was stuck in a open/ close cycle.
1)Replaced the HDD with new formatted NTFS.
2)Loaded Win XP professional.
3)Inserted CD with System and Application software which installed on option 2 (preserve data)
Bios is set to boot from CD.
When I now power on LogiQ it boots into XP,how do I get it to boot into the Ghost Ultrasound Application?
I only have the yellow application software disk.
Thank you.
I will do that thanks.I have another problem ; When I start another same machine the LogiQ sofware application loads but every time it says â no serial number associated with this machineâI have to insert the serial number every time and then the machine seems to work .Is it maybe a 3 Volt lithium backup battery ?Some setup that I must do?It is very annoying. Thanks.
Therapeutic Technologies closeout auctions take place on DOTmed.com. Bid today on 538 lots of medical equipment. Inspections may be done by appointment. Hours are Monday through Friday 9am-4pm Contact chrisnuytens1@gmail.com to schedule.
Marius Muller
GE LOGIQ C3
December 01, 2017 09:29
LogiQ would not boot,the DVD was stuck in a open/ close cycle.
1)Replaced the HDD with new formatted NTFS.
2)Loaded Win XP professional.
3)Inserted CD with System and Application software which installed on option 2 (preserve data)
Bios is set to boot from CD.
When I now power on LogiQ it boots into XP,how do I get it to boot into the Ghost Ultrasound Application?
I only have the yellow application software disk.
Thank you.
to rate and post a comment
ashok kumar
re: GE LOGIQ C3
December 02, 2017 11:54
No need to load xp professional os c2/c3 required only one DVD yellow that contains os and application. Try with yelllow dvd
to rate and post a comment
Marius Muller
re: re: GE LOGIQ C3
December 03, 2017 10:36
Thank you will do..
to rate and post a comment
ashok kumar
re: GE LOGIQ C3
December 02, 2017 11:55
No need to load xp professional os c2/c3 required only one DVD yellow that contains os and application. Try with yelllow dvd
to rate and post a comment
Marius Muller
re: re: GE LOGIQ C3
December 03, 2017 10:36
I will do that thanks.I have another problem ; When I start another same machine the LogiQ sofware application loads but every time it says â no serial number associated with this machineâI have to insert the serial number every time and then the machine seems to work .Is it maybe a 3 Volt lithium backup battery ?Some setup that I must do?It is very annoying. Thanks.
to rate and post a comment