MIT labs, experts in Multi-Vendor component level repair of: MRI Coils, RF amplifiers, Gradient Amplifiers Contrast Media Injectors. System repairs, sub-assembly repairs, component level repairs, refurbish/calibrate. info@mitlabsusa.com/+1 (305) 470-8013
Mohamad Ismail
GE Prestilix problem
August 30, 2005 10:08
Dear All
I have a problem in GE Prestilix Fluoroscopy system:
MPG50 generator - system 1600E(Table),
model no: 829648G015
The problem as follows:
When the system starting, an error (E40) appear and then disapper after 2 seconds, and the machine starting up,the warm up led flashing always, and continue flashing without stop.
I pushed the prep. Button ,the system is geting ready, when I going to take exposure the system gives alarm and an error (E120) appeared.
My questions:
-How I can resolve thins problem (E40) and what is mean the (E120) .
-Where is the position of boards, (CI-Reseau Board & Interface generateur).because they don't labled.
Thank you in advance.
to rate and post a comment
carlos barloqui
Re: GE Prestilix problem
September 20, 2005 09:24
Dear Sir,
The E40 error is tipical for Prestilix 1600E systems, This problem normally apear when the systems is ON to OFF Two times continuos, If its not case then the start cicuit have a resistor uot off value.
to rate and post a comment
ziad ammar
Re: GE Prestilix problem
June 13, 2007 03:17
hi mohamad if u need a help i m in beirut mail
tigrenokz@yahoo,com
to rate and post a comment