The user diagnostics enable the user to access several diagnostic capabilities. These capabilities enable the user to quickly diagnose system operational status or acquire the information needed to assist others in system diagnosis.
➤ To access the user diagnostics
1. Boot up the system.
2. Press Setups. The Directory of Setup Options is displayed.
3. Use the trackball to move the cursor to Diagnostics in the lower left corner of the display.
4. Press SELECT.
5. Move the cursor to the desired test or option. If the test or option is not highlighted with reverse video, press SELECT to highlight it.
6. Refer to the Comprehensive Test procedure to run the Comprehensive Test. For all other
tests or options, move the cursor to Start and press SELECT to initiate or display the results.
Maybe this will be of some help, I have full service manual.
Regards and good lock.
Jose
From preventive maintenance through comprehensive cryogen services, BMI-PMI is your trusted partner for new/reconditioned sales, installation, and service of both facility-based and mobile MRI solutions. www.brownsmedicalimaging.com / 800-701-9729
Manuel Casanova
HDI 5000 ERROR BOOTUP
July 01, 2010 06:36
DEARS ALL:
I have a error code when the system HDI 5000 is turn on:
FEATURE -DIAGS-Z ERROR BOOTUP TEST
0104-200011DA
ANY IDEA?
to rate and post a comment
Jose Vallejos
Re: HDI 5000 ERROR BOOTUP
July 02, 2010 03:39
Manuel,
The user diagnostics enable the user to access several diagnostic capabilities. These capabilities enable the user to quickly diagnose system operational status or acquire the information needed to assist others in system diagnosis.
➤ To access the user diagnostics
1. Boot up the system.
2. Press Setups. The Directory of Setup Options is displayed.
3. Use the trackball to move the cursor to Diagnostics in the lower left corner of the display.
4. Press SELECT.
5. Move the cursor to the desired test or option. If the test or option is not highlighted with reverse video, press SELECT to highlight it.
6. Refer to the Comprehensive Test procedure to run the Comprehensive Test. For all other
tests or options, move the cursor to Start and press SELECT to initiate or display the results.
Maybe this will be of some help, I have full service manual.
Regards and good lock.
Jose
to rate and post a comment