hdi 5000 color doppler machine giving the beep sound when i push the power(some times)and it is not work,i think this is a power problem but i am not sure,is this a power supply problem or electrical power problem.because machine normal working other place.same body help me?
This sytem has some good diagnostic tools for troubleshooting.
With the main power switch (breaker) ON, but the ON/Standby switch OFF, please verify on the ACIM board LEDs #6 and #7 are continuously lit. LED #6 indicates power is available to the HVDC transformer after the fuse, and LED #7 indicates HVDC is available to the PSM.
The beep you are hearing may indicate HVDC is not available to the PSM, preventing the system from starting.
If you have other questions, please post to this forum.
dear sir
i did chek the leds and hvdc is not available.
but electrical voltage 220 volt in the building.
i think this a electrical to ground problem.
thank your to answer.
Ophthalmic-focused expertise in YAG systems including repair, maintenance and calibration handled with precision by trained professionals. Request service • sales@laserlocators.com • 1-877-924-2020
kenan celik
hdi 5000
May 23, 2007 01:53
hdi 5000 color doppler machine giving the beep sound when i push the power(some times)and it is not work,i think this is a power problem but i am not sure,is this a power supply problem or electrical power problem.because machine normal working other place.same body help me?
to rate and post a comment
Jason Munson
Re: hdi 5000
May 24, 2007 09:30
Hi there!
This sytem has some good diagnostic tools for troubleshooting.
With the main power switch (breaker) ON, but the ON/Standby switch OFF, please verify on the ACIM board LEDs #6 and #7 are continuously lit. LED #6 indicates power is available to the HVDC transformer after the fuse, and LED #7 indicates HVDC is available to the PSM.
The beep you are hearing may indicate HVDC is not available to the PSM, preventing the system from starting.
If you have other questions, please post to this forum.
Respectfully,
Jason Munson
Echoserve, LLC
877-386-3246
to rate and post a comment
kenan celik
Re: hdi 5000
May 24, 2007 10:09
dear sir
i did chek the leds and hvdc is not available.
but electrical voltage 220 volt in the building.
i think this a electrical to ground problem.
thank your to answer.
to rate and post a comment