Hi,
I need service manual and some collegues
help to fix a problem with:
Philips C Arm:
BV LIBRA
If some one got experience with this model,
I would be very grateful if being in
contact with me.
Thanks in advance.
Alaa Mohammef
Hi my friend if you found a solution for your problem we have someone else who could use this helptoo.
Kindly advise if you are able to do it.
Here is the clip of his email to us explaining his problem:
Sir,
Hi my dear, i have the follow technical situation about this system, when start on, the booting at the external monitor attached vga output behind Workstation display CMOS error at bootup....AU Error au invalid in event ...., i was making a technical check to boards about c arm and i found 0 Vdc (lithium battery CR2032) in monoblock controller bd, and i was remplacing but the GENERATOR ERROR continue...and "checksum error" disappear...i think the generator calibration were erased and must restore it but i dont have calibration back up, but i have the service tool RUT software and interface cable..could help me to fix it...regards
BMI-PMI services nearly every make, model, and modality through our nationwide team of nearly 200 local service engineers. Flexible contracts, 24/7 remote monitoring, and ISO 13485 certification. www.brownsmedicalimaging.com / 800-701-9729
Alaa Mohammad
Help Philips C Arm: BV LIBRA
October 12, 2020 09:52
Hi,
I need service manual and some collegues
help to fix a problem with:
Philips C Arm:
BV LIBRA
If some one got experience with this model,
I would be very grateful if being in
contact with me.
Thanks in advance.
Alaa Mohammef
to rate and post a comment
shujo
re: Help Philips C Arm: BV LIBRA
October 13, 2020 09:53
Dear Mohammad,
We have this type X-ray machine. What problem you have?
Best ragards,
ing. Shujoadin Nizomov
Tajikistan, Dushanbe
to rate and post a comment
Gary Benitez
re: Help Philips C Arm: BV LIBRA
March 08, 2021 11:00
Hi my friend if you found a solution for your problem we have someone else who could use this helptoo.
Kindly advise if you are able to do it.
Here is the clip of his email to us explaining his problem:
Sir,
Hi my dear, i have the follow technical situation about this system, when start on, the booting at the external monitor attached vga output behind Workstation display CMOS error at bootup....AU Error au invalid in event ...., i was making a technical check to boards about c arm and i found 0 Vdc (lithium battery CR2032) in monoblock controller bd, and i was remplacing but the GENERATOR ERROR continue...and "checksum error" disappear...i think the generator calibration were erased and must restore it but i dont have calibration back up, but i have the service tool RUT software and interface cable..could help me to fix it...regards
to rate and post a comment