I have a GE Hispeed CT/i, the date and time not updated.
When the sytem is shutdown and powered up after several hour, the time at the console is not updated (observed the time appeared after boot-up is the time when the system was last shutdown).
I already replaced the NVRAM at IP22 board, reconfig and setting the dates and time on OC and SBC but still same problem occurred.
Alexander Tecson
HiSpeed Ct/i date and time problem
June 12, 2012 09:16
Good day,
I have a GE Hispeed CT/i, the date and time not updated.
When the sytem is shutdown and powered up after several hour, the time at the console is not updated (observed the time appeared after boot-up is the time when the system was last shutdown).
I already replaced the NVRAM at IP22 board, reconfig and setting the dates and time on OC and SBC but still same problem occurred.
Any help and suggestion? Thank you in advance.
to rate and post a comment
Dmitry Dederer
re: HiSpeed Ct/i date and time problem
June 16, 2012 11:41
Did you check the battery on the system board? The current must be not less than 3V.
to rate and post a comment