I have a problem with KONICA Li-7, "no image" seen in film after developing it.
The film and the solutions for developing and processing is also good.
No errors display into keypad, the connection between the source (ct-scan) to printer is good. I checked all the mechanical assembly inside the printer to see if I could find anythings obviously wrong, but everythings looks obsolutely good.I observed the beam window(camera) while grabbing the image,the window produced a red light -I performed it in the dark room area. Does anyone know what I should be seeing to window while in grabbing/printing. Does the red light stand for the laser for imaging?
If I remember correctly, if the film is loaded upside down then it will give a latent image - I think notch down in lower right hand corner is correct. Since everything else is normal maybe thats your answer.
BMI-PMI services nearly every make, model, and modality through our nationwide team of nearly 200 local service engineers. Flexible contracts, 24/7 remote monitoring, and ISO 13485 certification. www.brownsmedicalimaging.com / 800-701-9729
Alexander Tecson
Konica Laser Imager Li-7 -"image problem"
November 20, 2009 10:22
Good day,
I have a problem with KONICA Li-7, "no image" seen in film after developing it.
The film and the solutions for developing and processing is also good.
No errors display into keypad, the connection between the source (ct-scan) to printer is good. I checked all the mechanical assembly inside the printer to see if I could find anythings obviously wrong, but everythings looks obsolutely good.I observed the beam window(camera) while grabbing the image,the window produced a red light -I performed it in the dark room area. Does anyone know what I should be seeing to window while in grabbing/printing. Does the red light stand for the laser for imaging?
Thanks in advance,
Alexander Tecson
to rate and post a comment
RICH SEIDEMAN
Re: Konica Laser Imager Li-7 -"image problem"
November 20, 2009 07:09
If I remember correctly, if the film is loaded upside down then it will give a latent image - I think notch down in lower right hand corner is correct. Since everything else is normal maybe thats your answer.
to rate and post a comment
Alexander Tecson
Re: Konica Laser Imager Li-7 -"image problem"
November 21, 2009 11:47
Siedeman,
Thank you very much sir for the reply, we found out that the film is not compatible to the laser imager printer -dry type film (factory defect)..
GOD BLESS,
Alexander Tecson
to rate and post a comment