when choice accept after select tube warmup, error message was open" Failed...." So,go to log file "No device driver installed.Unabled to open the DIP device driver.
Pls advice to fix it.
DIP board is installed in DARC computer or SDDA case - depending on vertion of the system. I would start from DARC soft reloading or in case SDDA checking of SDDA power supply. after that LFC ...
We supply high-quality refurbished and used imaging equipment and parts to hospitals, imaging centers, and brokers worldwide. We pay top dollar and offer installation, deinstallation, service, and transport. Se habla español info@medilabglobal.com
SungHo Kang
Light speed 16 problem
June 14, 2011 06:40
when choice accept after select tube warmup, error message was open" Failed...." So,go to log file "No device driver installed.Unabled to open the DIP device driver.
Pls advice to fix it.
to rate and post a comment
Mariusz Figoluszka
Re: Light speed 16 problem
June 15, 2011 08:17
DIP board is installed in DARC computer or SDDA case - depending on vertion of the system. I would start from DARC soft reloading or in case SDDA checking of SDDA power supply. after that LFC ...
to rate and post a comment