I have a GE Lightspeed Pro16 (5.x) that I use as a Test Bay. I was working on the system and needed to rotate the gantry so I flipped the Service switch on the service panel on the right side of the gantry and then flipped the Axial Rotation switch to continuous rotation. The next thing I know, the PDU is buzzing and the 120VAC is Enabled but it isn't active on the gantry. Now the PDU doesn't buzz when the 120V switch is flipped on and the contactor sounds like it closes like normal but the 120V doesn't turn on like it should and the gantry gets no power. Ive tried power cycling the PDU and pressing the Emergency Switch off reset button on the PDU but nothings works. Does anyone have any ideas or has this happened to anybody? Any advice would be greatly appreciated.
Lightspeed 5.x Power Issue
June 21, 2017 10:09
I have a GE Lightspeed Pro16 (5.x) that I use as a Test Bay. I was working on the system and needed to rotate the gantry so I flipped the Service switch on the service panel on the right side of the gantry and then flipped the Axial Rotation switch to continuous rotation. The next thing I know, the PDU is buzzing and the 120VAC is Enabled but it isn't active on the gantry. Now the PDU doesn't buzz when the 120V switch is flipped on and the contactor sounds like it closes like normal but the 120V doesn't turn on like it should and the gantry gets no power. Ive tried power cycling the PDU and pressing the Emergency Switch off reset button on the PDU but nothings works. Does anyone have any ideas or has this happened to anybody? Any advice would be greatly appreciated.
to rate and post a comment