i have a problem with logiq 700 the machine ,starts with boot up sequence untill the application software is completly loaded . after that, a message is displayed notifying , that a button on the control panel is held down , i checked that all buttons are ok , checked all power supplies , connectors , cables ; the problem still exists
please help
thanks in advance
Is there a foot switch that could be the culptit? Try connecting a terminal to the service port to monitor the power on sequence. That will sometimes give more information that could be usefull.
Lightly used system available direct from the end user customer. MONARCH QUEST
Featuring our most advanced, data-driven navigation software with AI-Powered algorithms & advanced imaging integration with the GE HealthCare OEC 3D C-arm.
tahar nouri
Logiq 700 expert problem
February 02, 2011 01:21
Hi to all
i have a problem with logiq 700 the machine ,starts with boot up sequence untill the application software is completly loaded . after that, a message is displayed notifying , that a button on the control panel is held down , i checked that all buttons are ok , checked all power supplies , connectors , cables ; the problem still exists
please help
thanks in advance
to rate and post a comment
JORGE LUIS LOPEZ
Re: Logiq 700 expert problem
February 02, 2011 03:46
Did you check the button just below the led display those some times get stuck and can give the same error. hope this helps.
George.
to rate and post a comment
Bill Ward
Re: Logiq 700 expert problem
February 03, 2011 04:34
Is there a foot switch that could be the culptit? Try connecting a terminal to the service port to monitor the power on sequence. That will sometimes give more information that could be usefull.
to rate and post a comment