you need 4 MOD that have the software version
do you need just put the 1 of 4 in the mod drive and turn on the system when the system end of download itself will tel you taht change the disk for 2 of 4 and again and again then you reboot the system and the software is loaded
Hi let me tell you you dont need a password, or service key, i have performed this several time very easily
1. Install the new HDD
2.- Put the first of the 4 disk in the DISK LECTOR and turn on the system
3. the disk will start the loading and when it finish ond the VF display(the green one) will apear " load disk 2" after the 3 and 4 and is done.
if you have the extra option load in the same way
If it's a logiq 700 pro series you will need only 3 MOD's if ti's a expert series then 4 MOD's are required, if you want to know, more specific what is the machine is doing on the instalation, you can hook up a laptop on the service port.
Hope this helps.
George lopez
Malko TENFACK
Logiq 700 install software procedure
April 19, 2011 09:39
Procedure to install software in new hard drive.
Thank for your replies.
to rate and post a comment
yuan bo
Re: Logiq 700 install software procedure
April 20, 2011 09:34
it's easy, please consult the service manual, but you need the bios password to install the software.
to rate and post a comment
Malko TENFACK
Re: Logiq 700 install software procedure
May 05, 2011 09:17
You have Default bios password?
to rate and post a comment
manuel valdez
Re: Logiq 700 install software procedure
May 03, 2011 02:23
you need 4 MOD that have the software version
do you need just put the 1 of 4 in the mod drive and turn on the system when the system end of download itself will tel you taht change the disk for 2 of 4 and again and again then you reboot the system and the software is loaded
to rate and post a comment
rossana diaz
Re: Logiq 700 install software procedure
June 20, 2011 12:53
Hi let me tell you you dont need a password, or service key, i have performed this several time very easily
1. Install the new HDD
2.- Put the first of the 4 disk in the DISK LECTOR and turn on the system
3. the disk will start the loading and when it finish ond the VF display(the green one) will apear " load disk 2" after the 3 and 4 and is done.
if you have the extra option load in the same way
to rate and post a comment
JORGE LUIS LOPEZ
Re: Logiq 700 install software procedure
May 04, 2011 06:51
If it's a logiq 700 pro series you will need only 3 MOD's if ti's a expert series then 4 MOD's are required, if you want to know, more specific what is the machine is doing on the instalation, you can hook up a laptop on the service port.
Hope this helps.
George lopez
to rate and post a comment