We provide sales, service, rental, and repair for ultrasound systems, probes, and C-arms. We have the largest inventory in the world. Contact us about our special offers on certified refurbished equipment! Call: 317-759-9210 Email: sales@probomedical.com.
Youbissi Pascal
Logiq100 MP
March 06, 2014 10:31
Hello every body,
I have vertical line on right side of screen. I have check if it is a monitor by trying printing some image the same line appears on paper.
Please help me solving this problem
to rate and post a comment
walter molina
re: Logiq100 MP
March 07, 2014 07:36
May be you need reset all tje board and reconect all cables inside the US, and the vertical line appear with other probes?
Best regards
to rate and post a comment
Youbissi Pascal
re: re: Logiq100 MP
March 07, 2014 09:13
Dear Walter, thank you for your answer, I have disconnected all cables but it stil appears.
to rate and post a comment
Marcelo Antonio Correa
re: re: re: Logiq100 MP
March 07, 2014 09:30
Hi, Pascal!
Walter is right. Make a deep inner clean and check all connections.
Dust and moisture use to give this kind of issue in some L100.
But, you could also suspect probe connector or probe itself.
I understand you're referring of something related to video signal, and reattaching the boards could solve.
Reattach all socket ICs, too.
Othewise, you probably have a defective board.
Hope this helps.
Take care, great weekend, God Bless.
MAC.
to rate and post a comment
walter molina
re: re: re: Logiq100 MP
March 08, 2014 07:24
the line appear with another probes?
to rate and post a comment
Youbissi Pascal
re: re: re: re: Logiq100 MP
March 10, 2014 08:33
Yes Walter it appears with all probes
to rate and post a comment
walter molina
re: re: re: re: re: Logiq100 MP
March 11, 2014 08:05
the line appear in all monitor or only in scan area?
to rate and post a comment
Youbissi Pascal
re: re: re: re: re: re: Logiq100 MP
March 11, 2014 11:43
Only in scan area
to rate and post a comment
walter molina
re: re: re: re: re: re: re: Logiq100 MP
March 11, 2014 03:59
sorry one question.more , when you see image.in scan area tje image are good,you have a good deep? can you send me a picture? i have a same problem in my problem was a capicitor lose in a board its next to probe board conector. if you can get out all the.boards and see slow touch the all capacitor.
when i resolding my bad capacitor the problem its finish
to rate and post a comment