I've got the Error 30 whenever somebody tries to make an exposure. The X ray tube Wwas replaced before and it worked just fine for a few days, but now it won't make an exposure, not in Manual, Auto KV, Auto time and in Auto Filter modes.
Check the image receptor, check the pins on the receptor. Did you try using a different receptor?
Error Message: System Error 30
Source:Image Receptor MP
Description: Host data error
possible Fix: Host software locked-up
Hi Lenny, I have not tried with another Image receptor, I will though...I had before and error 20 and then error 30.. I checked the tube rotor, and it was going bad already, so I replaced the tube... so when I installed the tube last monday, I did not have any issue... until wednesday that I could not make an exposure.
I need an email address to send you the manuals. Unless the battery dies on the CPU board or you replace a part you should not have to do the calibrations
BMI-PMI services nearly every make, model, and modality through our nationwide team of nearly 200 local service engineers. Flexible contracts, 24/7 remote monitoring, and ISO 13485 certification. www.brownsmedicalimaging.com / 800-701-9729
FranciscoG
Lorad MIV Error 30
July 19, 2017 10:50
Hi guys,
I've got the Error 30 whenever somebody tries to make an exposure. The X ray tube Wwas replaced before and it worked just fine for a few days, but now it won't make an exposure, not in Manual, Auto KV, Auto time and in Auto Filter modes.
Could someone help me here?
Thanks in advance
to rate and post a comment
juan pablo amado
re: Lorad MIV Error 30
July 20, 2017 10:07
Error 30: error in data from host. Error may indicate software lockup with the host. Origin: image receptor microprocessor
to rate and post a comment
FranciscoG
re: re: Lorad MIV Error 30
July 23, 2017 04:45
Thanks Juan Pablo, I will try to test this image receptor on another system.
to rate and post a comment
Lenny Place
re: Lorad MIV Error 30
July 21, 2017 05:05
Check the image receptor, check the pins on the receptor. Did you try using a different receptor?
Error Message: System Error 30
Source:Image Receptor MP
Description: Host data error
possible Fix: Host software locked-up
to rate and post a comment
FranciscoG
re: re: Lorad MIV Error 30
July 23, 2017 04:45
Hi Lenny, I have not tried with another Image receptor, I will though...I had before and error 20 and then error 30.. I checked the tube rotor, and it was going bad already, so I replaced the tube... so when I installed the tube last monday, I did not have any issue... until wednesday that I could not make an exposure.
to rate and post a comment
FranciscoG
re: re: Lorad MIV Error 30
July 23, 2017 04:45
Hi Lenny, I think I must do calibrations... so you have the service manual with calibrations you can share with me?
to rate and post a comment
Lenny Place
re: re: re: Lorad MIV Error 30
July 24, 2017 10:42
I need an email address to send you the manuals. Unless the battery dies on the CPU board or you replace a part you should not have to do the calibrations
to rate and post a comment
FranciscoG
re: re: re: re: Lorad MIV Error 30
July 24, 2017 03:43
francisco.garcia@bioradx.com
to rate and post a comment