I have service manual FX-8c. Sistem alarm number is show in cut display (error codes?). the number 161 not exist .
160 yes an say this : Internal component malfunction. Dosage
error test failed. ADC values display at
failure
Calibrate the ECON factor. Refer to Section 5 for instructions.
If the alarm number reappears, refer to Correcting T_ON ASIC
Malfunctions in this section.
Thanks to all, Problem solved, found that the problem was related to cod.161 step of cutting power, the FET Board that was shorted. Equipment was replaced and returned to normal operation. Thanks for the help.
Online auction of modern high-end laboratory and biopharma research equipment from the recent bankruptcy of Spexis AG in Allschwil near Basel, Switzerland. Start bidding today! closes on June 4. info@dome-auctions.com..+31(0)20 808 2880
Cledson Silva
Manual Service Force FX Error Code 161
April 30, 2013 05:14
Could someone provide the service manual Force Fx or someone has seen the error 161? Thank's
to rate and post a comment
Glenn FRITSCH
re: Manual Service Force FX Error Code 161
May 01, 2013 10:21
Try http://www.frankshospitalworkshop.com/equipment/electrosurgery_service_manuals.html
you can download the manual for the FX
to rate and post a comment
Cledson Silva
re: re: Manual Service Force FX Error Code 161
May 02, 2013 10:44
Thank you Mr. Glenn I solved the problem and posted in the forum..
I hope this information can help.
to rate and post a comment
sanjay kumar
re: re: re: Manual Service Force FX Error Code 161
April 01, 2014 07:53
Could someone provide the service manual Force Fx or someone has seen the error 161?
(sanjaykmr703@gmail.com)
to rate and post a comment
Glenn FRITSCH
re: Manual Service Force FX Error Code 161
May 01, 2013 10:21
http://www.frankshospitalworkshop.com/equipment/electrosurgery_service_manuals.html
go here for the manual
to rate and post a comment
sanjay kumar
re: re: Manual Service Force FX Error Code 161
April 01, 2014 07:53
Could someone provide the service manual Force Fx or someone has seen the error 161? (sanjaykmr703@gmail.com)
to rate and post a comment
FRANCISCO JAVIER RAMIREZ NAVA
re: Manual Service Force FX Error Code 161
May 01, 2013 10:21
I have service manual FX-8c. Sistem alarm number is show in cut display (error codes?). the number 161 not exist .
160 yes an say this : Internal component malfunction. Dosage
error test failed. ADC values display at
failure
Calibrate the ECON factor. Refer to Section 5 for instructions.
If the alarm number reappears, refer to Correcting T_ON ASIC
Malfunctions in this section.
to rate and post a comment
William Clarke
re: Manual Service Force FX Error Code 161
May 01, 2013 10:23
Send me your e mail address and I will send manual.
wlcbmt@aol.com
to rate and post a comment
sanjay kumar
re: re: Manual Service Force FX Error Code 161
April 01, 2014 07:53
sanjaykmr703@gmail.com
to rate and post a comment
Cledson Silva
re: Manual Service Force FX Error Code 161
May 02, 2013 10:44
Thanks to all, Problem solved, found that the problem was related to cod.161 step of cutting power, the FET Board that was shorted. Equipment was replaced and returned to normal operation. Thanks for the help.
to rate and post a comment