Status on console monitor displays:
"Landmark is lost due to SRP Reset
Move table all the way out, then establish landmark"
Viewlog:
Error 2240106
"The cradle must be at outlimit when you want to up/down the table
Please move the cradle manually, and make sure the outlimit LED is turned on"
Table is outlimit, outlimit sensor works and led on display is turnes on i can see on SRP assy INTR LED turns on when outlimit optical sensor is actuated, and I can check that RL1 is energized when I press UP button on panel. But table does not comes up.
Any idea about solution?
Altima will inspire the trust, loyalty and commitment of our customers through positive relationships and collaboration, top quality equipment services, and a clearly superior value proposition. Call Today (469) 644-7063
Manuel Esquer
MRI Contour 3 Table problem
January 25, 2013 11:41
Table does not go up.
Status on console monitor displays:
"Landmark is lost due to SRP Reset
Move table all the way out, then establish landmark"
Viewlog:
Error 2240106
"The cradle must be at outlimit when you want to up/down the table
Please move the cradle manually, and make sure the outlimit LED is turned on"
Table is outlimit, outlimit sensor works and led on display is turnes on i can see on SRP assy INTR LED turns on when outlimit optical sensor is actuated, and I can check that RL1 is energized when I press UP button on panel. But table does not comes up.
Any idea about solution?
to rate and post a comment