I have Siemens Multix Pro P touch screen console image display disappear...It happen sometimes maybe 2 or 3 times, then turns off completely, and no display at all...I've already cleaned all possible connections loose.
if the display is lost , then probabily a fuse burn in the device of high voltage , there are a fuses very small like a 2 milimeters in it . be paciently.
Hi Tibor Ivanszky, thank for your reply. I did not visit yet coz is too far in our place. Regarding your question for whole system shut down? No is not, only console no image display, but there is power supply on the console. thanks
Roberto reminded me the case I already experienced once and I soldered a thin wire over the SMD fuse responsible for the supply of the HV power supply of the fluorescent backlight. This may help if no more serious problem with this tiny PCB.
We supply high-quality refurbished and used imaging equipment and parts to hospitals, imaging centers, and brokers worldwide. We pay top dollar and offer installation, deinstallation, service, and transport. Se habla español info@medilabglobal.com
JUNSA
MULTIX PRO P TOUCH SCREEN NO DISPLAY
May 03, 2014 01:55
Hi to All!
I have Siemens Multix Pro P touch screen console image display disappear...It happen sometimes maybe 2 or 3 times, then turns off completely, and no display at all...I've already cleaned all possible connections loose.
Any help...ideas are welcome.
to rate and post a comment
Tibor Ivanszky
re: MULTIX PRO P TOUCH SCREEN NO DISPLAY
May 04, 2014 08:25
Backlight power supply fault. Is the touchscreen active during blackout?
to rate and post a comment
Tibor Ivanszky
re: MULTIX PRO P TOUCH SCREEN NO DISPLAY
May 05, 2014 04:07
Do you mean the whole system shuts down finally?
to rate and post a comment
Roberto_Roth
re: re: MULTIX PRO P TOUCH SCREEN NO DISPLAY
May 06, 2014 11:10
if the display is lost , then probabily a fuse burn in the device of high voltage , there are a fuses very small like a 2 milimeters in it . be paciently.
to rate and post a comment
JUNSA
re: re: re: MULTIX PRO P TOUCH SCREEN NO DISPLAY
May 07, 2014 09:48
Hi Robert, thanks for your concern and comments I will try to do that...
to rate and post a comment
JUNSA
re: re: MULTIX PRO P TOUCH SCREEN NO DISPLAY
May 07, 2014 09:48
Hi Tibor Ivanszky, thank for your reply. I did not visit yet coz is too far in our place. Regarding your question for whole system shut down? No is not, only console no image display, but there is power supply on the console. thanks
to rate and post a comment
Tibor Ivanszky
re: re: re: MULTIX PRO P TOUCH SCREEN NO DISPLAY
May 07, 2014 01:23
Roberto reminded me the case I already experienced once and I soldered a thin wire over the SMD fuse responsible for the supply of the HV power supply of the fluorescent backlight. This may help if no more serious problem with this tiny PCB.
to rate and post a comment