The image shows vertical lines instead of complete homoginized round image when a flood is imaged. Was ok before the collimator was replaced. Did the same behaviour before once but after restarting became ok. Now after every effort it is still showing thick parallel lines almost 6 in number on the image monitor. What could have become wrong. Is the detector cable out of order or detectors positional electronics went faulty due to any loose joint in PCB which could have occured due to some movement of detector.
Zeeshan Sadiq
Nuclear Camera Starcam 3200
August 15, 2005 02:32
The image shows vertical lines instead of complete homoginized round image when a flood is imaged. Was ok before the collimator was replaced. Did the same behaviour before once but after restarting became ok. Now after every effort it is still showing thick parallel lines almost 6 in number on the image monitor. What could have become wrong. Is the detector cable out of order or detectors positional electronics went faulty due to any loose joint in PCB which could have occured due to some movement of detector.
to rate and post a comment