hello friends I have a problem in a CT NXI the same standard application put up right after the automatic shutdown already reinstalled the software and changed but the hds but the problem remains the same anyone ever seen something like I'm using a dedicated core NXI 5.0 application, and the patch 5.0.
Ps when I climb by using the setenv NOHOSTSHUTDOWN the machine is waiting to wake up the gantry.
Probably is a revision level failure, the lowest level used for NXi i saw is 5.50.
I experienced in the past trying wrong revision level for different models the same thing.
already tried loading with version 5.50 and with the core application and patch 6 but I can not install fault preconfig. You could tell me which version to use I knew NXI is a dedicated version? grateful.
Try 5.50 and NO patches.
Additionally, do not configure print and network values...sometimes when you do that at LFC, problems appears. You can setup that values after.
Lightly used system available direct from the end user customer. MONARCH QUEST
Featuring our most advanced, data-driven navigation software with AI-Powered algorithms & advanced imaging integration with the GE HealthCare OEC 3D C-arm.
Caio Pgri
NXI problem automatic shutdown
February 18, 2013 08:16
hello friends I have a problem in a CT NXI the same standard application put up right after the automatic shutdown already reinstalled the software and changed but the hds but the problem remains the same anyone ever seen something like I'm using a dedicated core NXI 5.0 application, and the patch 5.0.
Ps when I climb by using the setenv NOHOSTSHUTDOWN the machine is waiting to wake up the gantry.
to rate and post a comment
Carlos Duran
re: NXI problem automatic shutdown
February 18, 2013 09:57
Probably is a revision level failure, the lowest level used for NXi i saw is 5.50.
I experienced in the past trying wrong revision level for different models the same thing.
to rate and post a comment
Caio Pgri
re: re: NXI problem automatic shutdown
February 19, 2013 06:23
already tried loading with version 5.50 and with the core application and patch 6 but I can not install fault preconfig. You could tell me which version to use I knew NXI is a dedicated version? grateful.
to rate and post a comment
Carlos Duran
re: re: re: NXI problem automatic shutdown
February 19, 2013 10:22
Try 5.50 and NO patches.
Additionally, do not configure print and network values...sometimes when you do that at LFC, problems appears. You can setup that values after.
to rate and post a comment