Please give more details such as was this unit working good for you previously or did you just get this unit in and is giving you this error?What happens after rebooting system?
A B6 usually is a CART boot up problem, unplug the c-arm interconnect cable. then try to boot just the cart.... the cart will more than likely NOT boot up.... check power supplies in CART.... could be software, hard drive..board
this error means that the monitor cart hard drive is not booting correctly but if you want check the voltages at the conector even I am almost sure that is the hd
HIGH QUALITY fully tested & refurbished systems to manufacturer specifications like new. Installation & service support worldwide. Parts & tubes in stock with warranty. Sales@Elsmed.com
Alex Clavijo
OEC 9000 B6 error
February 08, 2007 12:57
I have an OEC 9000 and it is flashing a B6 error. Does anyone know what this means? I aprreciate anyones advise.
to rate and post a comment
Joe Zaremba
Re: OEC 9000 B6 error
February 08, 2007 03:38
Please give more details such as was this unit working good for you previously or did you just get this unit in and is giving you this error?What happens after rebooting system?
to rate and post a comment
Robert M Rizo
re: Re: OEC 9000 B6 error
December 06, 2013 07:03
It was working before, but diagnostic was the HD, so we replace it, and still same issue, it get stock on b6 booting
to rate and post a comment
mehdi zafarnia
Re: OEC 9000 B6 error
February 09, 2007 09:52
I suspect you are having problem with power supply board. There are two Caps on the board, if they start to go bad, they will cause this problem.
Regards,
to rate and post a comment
Russ Bodin
Re: OEC 9000 B6 error
February 09, 2007 10:55
A B6 usually is a CART boot up problem, unplug the c-arm interconnect cable. then try to boot just the cart.... the cart will more than likely NOT boot up.... check power supplies in CART.... could be software, hard drive..board
to rate and post a comment
Robert M Rizo
re: Re: OEC 9000 B6 error
December 06, 2013 07:03
We all ready do that, and same b6
to rate and post a comment
Robert M Rizo
re: Re: OEC 9000 B6 error
December 06, 2013 07:03
We replace the HD and the disk interface as well
to rate and post a comment
Joel Grullon
Re: OEC 9000 B6 error
February 09, 2007 11:48
this error means that the monitor cart hard drive is not booting correctly but if you want check the voltages at the conector even I am almost sure that is the hd
to rate and post a comment
Robert M Rizo
re: Re: OEC 9000 B6 error
December 06, 2013 07:03
We have replace the HD twice and still same
to rate and post a comment