It sounds like either your floppy drive or boot disk have gone bad. If I remember correctly if you take off the shell of the base of the C-Arm you should see a 3 1/2" floppy disk drive on the right side. You can test the drive to see if that is the issue. If it is the disk, then unless if you have a backup which I would think you most likely do not because those are ofter overlooked you might be up a creek.
If I am wrong on the location of the drive, it may be on the monitor cart, but I am prety sure it is onder the shell of the C-Arm.
BMI-PMI services nearly every make, model, and modality through our nationwide team of nearly 200 local service engineers. Flexible contracts, 24/7 remote monitoring, and ISO 13485 certification. www.brownsmedicalimaging.com / 800-701-9729
Edwin Rosado
OEC 9000 boot problem
August 29, 2013 05:48
when i turn on the system the monitor cart display stay at B% and the C-ARM display at b7, any suggestion.
to rate and post a comment
Mike Erlanson
re: OEC 9000 boot problem
August 30, 2013 06:53
It sounds like either your floppy drive or boot disk have gone bad. If I remember correctly if you take off the shell of the base of the C-Arm you should see a 3 1/2" floppy disk drive on the right side. You can test the drive to see if that is the issue. If it is the disk, then unless if you have a backup which I would think you most likely do not because those are ofter overlooked you might be up a creek.
If I am wrong on the location of the drive, it may be on the monitor cart, but I am prety sure it is onder the shell of the C-Arm.
to rate and post a comment
Edwin Rosado
re: re: OEC 9000 boot problem
August 31, 2013 09:47
thanks, the monitor cart is B8, the monitor cart had a disk drive and the main frame had a floppy drive. i think my problem is in the monitor cart.
to rate and post a comment