can some body help me? this machine an oec 9000 diasonics is stocked in the stage b8 I suppose can be the technique proc. board but I need be sure for change it ,exist any cause external that could generated this error ,please some body help is urgent... thanks joel
Joel,This comes up as a technique processor boot error code. However I have a list of things to check before replacing the TP board. 1.Check all supply voltages. 2.Check all connectors and cable and reseat them. 3.Check the time and date settings. 4.The book says you could have an eeprom mismatch(serial number mismatch). 5.Floppy drive/jumpers/switches. 6.Corrupted software diskette. Use the backup if you have one. 7.Replace TP board. Good luck!
Deon
the eeprom mismatch ,the software into the diskette must match with the software into the eeprom ? , the question is because I allready changed the board and then I sure all is fine less the new board
Altima will inspire the trust, loyalty and commitment of our customers through positive relationships and collaboration, top quality equipment services, and a clearly superior value proposition. Call Today (469) 644-7063
Joel Grullon
OEC 9000 Error B8
May 08, 2007 11:54
can some body help me? this machine an oec 9000 diasonics is stocked in the stage b8 I suppose can be the technique proc. board but I need be sure for change it ,exist any cause external that could generated this error ,please some body help is urgent... thanks joel
to rate and post a comment
Deon Armes
Re: OEC 9000 Error B8
May 10, 2007 04:22
Joel,This comes up as a technique processor boot error code. However I have a list of things to check before replacing the TP board. 1.Check all supply voltages. 2.Check all connectors and cable and reseat them. 3.Check the time and date settings. 4.The book says you could have an eeprom mismatch(serial number mismatch). 5.Floppy drive/jumpers/switches. 6.Corrupted software diskette. Use the backup if you have one. 7.Replace TP board. Good luck!
Deon
to rate and post a comment
Joel Grullon
Re: OEC 9000 Error B8
May 13, 2007 08:28
the eeprom mismatch ,the software into the diskette must match with the software into the eeprom ? , the question is because I allready changed the board and then I sure all is fine less the new board
to rate and post a comment
Rick Ebling
re: Re: OEC 9000 Error B8
November 08, 2012 03:27
Deon , where are you located
to rate and post a comment