When I test and teast and test send error on display(not remember wich ones) Wich values must verify?(+-12,5,24) on Carm or monitor cart?Exist a jumper to enter service?Speak spanish?
Thank you
Hi, I hope this is good. Mita I have a problem with a c-arm OEC 9000 the equipment starts without errors and generates x-rays and image in the monitor live but at the moment of releasing the switch or pedal of x ray or fluoro I generate the error E7 in the car of monitors , The communication is verified and is perfect, you can help me in indicating what the problem may be
Ophthalmic-focused expertise in YAG systems including repair, maintenance and calibration handled with precision by trained professionals. Request service • sales@laserlocators.com • 1-877-924-2020
eduardo medina
OEC 9000 PROBLEM
September 11, 2008 11:50
AFTER SOME MINUTES DOING FLURO,DISPLAYS ON CONSOLE OFF,YOU MUST TURN OFF WAIT MINUTES AND DO IT AGAIN. SOME IDEA? THANK YOU
to rate and post a comment
Joel Grullon
Re: OEC 9000 PROBLEM
September 15, 2008 08:18
if the equipment is not showing any error so u need to check if the power sup. is fine before say the correct trouble. check the technique processor
to rate and post a comment
eduardo medina
Re: OEC 9000 PROBLEM
September 16, 2008 02:11
When I test and teast and test send error on display(not remember wich ones) Wich values must verify?(+-12,5,24) on Carm or monitor cart?Exist a jumper to enter service?Speak spanish?
Thank you
to rate and post a comment
alejandro mendoza
Re: OEC 9000 PROBLEM
September 16, 2008 05:09
contactame a_lex @hotmail.com
regards!
to rate and post a comment
CARLOS PAEZ
re: Re: OEC 9000 PROBLEM
February 13, 2017 10:21
Hi.
Hi, I hope this is good. Mita I have a problem with a c-arm OEC 9000 the equipment starts without errors and generates x-rays and image in the monitor live but at the moment of releasing the switch or pedal of x ray or fluoro I generate the error E7 in the car of monitors , The communication is verified and is perfect, you can help me in indicating what the problem may be
Best Regards
Carlos Páez
to rate and post a comment