I am having an image problem with an OEC 9400. When I shoot an x-ray, I get two identical images, one on top of the other with a horizontal black line separating the two. When I columnate, it shows up on both images simultaneously. This c-arm has been used for research in which the camera assembly had been replaced with a digital unit attached to a computer without any issues. But when the original camera assembly was reattached, this problem was noticed. Is this a camera problem? Image processing? Any help would be greatly appreciated. Thanks! Jeff
Thanks Chris. Let me elaborate further on the problem. When I take a shot, either a single shot or fluoro, I get a white circle with a horizontal black line bisecting the circle in the middle, dividing the circle into two half-circles, one above and below. There are two identical images on the top and bottom of the black line. It's like I'm looking at a film strip, in between two images. Adjusting the potentiometers (centering, right/left) on the deflection board of the camera assembly move the images around a little but do not change the black line that is bisecting the two images. I checked the jumpers and they are all in factory positions as per service manual.
Any other ideas?
Thanks!
Jeff
Ophthalmic-focused expertise in YAG systems including repair, maintenance and calibration handled with precision by trained professionals. Request service • sales@laserlocators.com • 1-877-924-2020
jeffrey ward
OEC 9400 double image
October 02, 2009 09:30
I am having an image problem with an OEC 9400. When I shoot an x-ray, I get two identical images, one on top of the other with a horizontal black line separating the two. When I columnate, it shows up on both images simultaneously. This c-arm has been used for research in which the camera assembly had been replaced with a digital unit attached to a computer without any issues. But when the original camera assembly was reattached, this problem was noticed. Is this a camera problem? Image processing? Any help would be greatly appreciated. Thanks! Jeff
to rate and post a comment
Chris Baklik
Re: OEC 9400 double image
October 06, 2009 10:58
Jeff
I would check all your program jumper setting again on the 9400 and your jumper setting on the camera are correct.
to rate and post a comment
jeffrey ward
Re: OEC 9400 double image
October 10, 2009 06:08
Thanks Chris. Let me elaborate further on the problem. When I take a shot, either a single shot or fluoro, I get a white circle with a horizontal black line bisecting the circle in the middle, dividing the circle into two half-circles, one above and below. There are two identical images on the top and bottom of the black line. It's like I'm looking at a film strip, in between two images. Adjusting the potentiometers (centering, right/left) on the deflection board of the camera assembly move the images around a little but do not change the black line that is bisecting the two images. I checked the jumpers and they are all in factory positions as per service manual.
Any other ideas?
Thanks!
Jeff
to rate and post a comment